NoteThis device is intended for use on Class 2 circuits only. Use only on low voltage circuits with output ranges identified in specifications. These lamps may be dimmed using analog dimmers and magnetic transformers. May not be compatible with all dimmers and/or transformers and should be tested in application for compatibility prior to full installations on circuits using such devices. Not for use on timing devices, photo sensors or occupancy sensors. Caution: Risk of electric shock. Never disassemble or modify the bulb, no user serviceable parts inside.To avoid burns, do not touch the bulb during operation and allow to cool completely after switching off. This device is not intended for use in emergency exit fixtures. This device complies with Part 18 of the FCC rules. This product may cause interference with other devices. If interference occurs, change the location of the products involved. Do not use where directly exposed to water. Approved for use in sealed metal landscape fixtures. Do not use in totally enclosed fixtures or IC or ICAT rated recessed cans. Dimmable lamps dim down to 5%, but are limited by the dimming device range. Lamp is UL approved for damp locations. Risk of electric shock. UL rated for damp location. To avoid burns, do not touch the bulb during operation and allow to cool completely after switching off. Not for use in totally enclosed fixtures. Acceptable for use in insulated contact airtight (ICAT) rated fixtures. This device is not intended for use with emergency exit fixtures. If this product causes interference with other devices, change the location of the products involved. Use only on 10-18 volt circuits. To view the product packaging, click here.
